The human isolates from the RIVM were all, except two, isolated from patients in The Netherlands between 1969 and 2008. The strains, together with additional information, are shown in Additional file 1: Table S1. MLVA analysis The target DNA for polymerase chain reaction (PCR) assays was extracted by heating bacterial suspensions in sterilized, demineralized water for 90 min at 95°C. The amplification of the different variable-number tandem repeats (VNTR) was performed as previously described [18, 19, 29–31]. Moreover, as described by Al Dahouk et al., an additional VNTR was added Selleckchem Anlotinib to the initial MLVA-15

[18, 19, 29, 30]. The PCR amplification was performed in 15-μl volumes containing 1U FastStart Taq polymerase (Roche), 1 × PCR Roche reaction buffer (10 mM Tris-HCl, 2.5 mM MgCl2, and 50 mM KCl at pH 8.3), 0.2 mM dNTPs (Roche) and 0.3 μM of each flanking primer. Thermal cycling, conducted on a Peltier DihydrotestosteroneDHT nmr Thermal Cycler DNA Engine DYAD (MJ Research), was performed as follows: an initial heating at 95°C for 5 min followed by 35 cycles of denaturation at 95°C for 30 sec, annealing at 60°C for 30 sec and

extension at 70°C for 60 sec. A final extension was performed at 70°C for 5 min. Lab-on-a-chip genotyping was used as previously described to analyze the number of tandem repeats in each locus [18]. The amplification products were loaded into a 96-well or 384-well PCR plates that were prepared according to the manufacturer’s recommendations (Caliper HT DNA 5 K Kit, Caliper Life Sciences, Hopkinton, USA). Each chip contained 5 active wells: 1 for the DNA marker and GNA12 4 for the gel-dye solution. A marker ladder of MW 100, 300, 500, 700, 1, 100, 1, 900, 2, 900, and 4, 900 bp was used for referencing the molecular weight. The number of samples per chip preparation was 400, equivalent to four 96-well plates or one 384-well plate. After gel

preparation, the sample plate was loaded into the plate carrier attached to the robot of the Caliper LabChip 90 (Caliper Life Sciences). During the separation of the fragments, the samples were analyzed sequentially, and electropherograms, virtual gel images and tabulated data were shown. The amplification product size estimates were obtained using the LabChip GX (Caliper Life Sciences) [18]. For each fragment size, the corresponding allele was assigned using the conversion table that was previously described [18]. The assigned number of each tandem repeat was imported into the Cediranib in vivo BioNumerics software package (version 5.10, Applied Maths, Belgium). A clustering analysis was performed using the unweighted pair-group method using arithmetic averages (UPGMA).